REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 6 (2002 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mazda
	6
		Operation and maintenance of car
		Engine
		Transmission
		Chassis
		Steering Gear
		Brakes
		Onboard electric
		Body
			Overview
				The design of the car with a body "sedan"
				The design of the car with a body "hatchback"
				Body shell
				Curtain and decorative components of a body
					Removing and installing bonnet
					Adjusting the hood
					Removal and installation of the panel front wing
				Door
				Windows
				Disassembly and assembly of the boot lid
				Removing and installing front bumper
				Disassembly and assembly of the front bumper
				Removing and installing rear bumper
				Removing and installing rear trim
				Removing and installing rear spoiler
				Outside mirrors
				Removal and installation of external electric mirrors
				Disassembly and assembly of the external electric mirrors
				Rear Defrost
				Sunroof
				Seat belts
				Seats
			Air conditioning and heating

printable version

Removing and installing bonnet

Disconnect the washer hose.

To remove the hood hinges, remove the cover of the front wing.

To remove the hood latch, remove the radiator grille.

To remove the cable lock of a cowl, remove the mud guard with the driver's side.

Fig. 8.10. Removing the hood: 1 - hood insulator; 2 - the seal housing; 3 - the separation of the seal; 4 - hood; 5 - hood hinges; 6 - support the hood; 7 - switch connector hood (with alarm system); 8 - lock hood; 9 - the bonnet release lever; 10 - wire bonnet

Remove in the order shown in Figure 8.10.

Install in the reverse order of removal.

Adjust the position of the hood.

« previos page
Curtain and decorative components of a body

next page »
Adjusting the hood