REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 6 (2002 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mazda
	6
		Operation and maintenance of car
		Engine
		Transmission
			Clutch
			Manual Transmission
				Overview
				Checking and changing the oil in a mechanical transmission
				Removing and installing speedometer car (without DLD)
				Replacing the oil seal (differential)
				Removing and installing gearshift
				Carter clutch housing demolition elements of the main transfer
				Testing and assembly of components of the differential and final drive housing
					Installing bearing toothed gears
					Assembling the roll pin
					Adjust the preload in the bearing
					Setting the differential in the clutch
					Installing crankcase main gear
					Eliminating gaps primary, secondary shaft and the shaft of the differential housing of the main transfer
					Measurement of the load of the primary, secondary shaft and the shaft of the differential housing of the main transfer
			Automatic transmission
			Drive Train
		Chassis
		Steering Gear
		Brakes
		Onboard electric
		Body

printable version

Adjust the preload in the bearing

Install the bearing race primary and secondary shaft in the crankcase of the main transfer (gasket removed).

Install the clutch housing to eye transmission in the block with the main transfer, set the differential bearing race into the clutch housing. Place a piece of pipe on the bearing race and press in until it stops in the clutch housing.

Fig. 3.55. Installing the bearing race in the special tools

Install the bearing race in the special tool (selector) as shown in Figure Fig. 3.55.

NOTE

Turn the selector to eliminate the gap indicated by the arrow in Figure 3.55.

« previos page
Assembling the roll pin

next page »
Setting the differential in the clutch