 printable version
Indication of time
The display shows the current time when the ignition switch is in the ?«ON?» (ignition switched on) or "ACC" (auxiliary power consumers). If the displayed trip computer data, press the ?«CLOCK?» (hours) in order to switch the display to indicate the current time.
NOTE On vehicles with trip computer, setting the clock, use the button ?«INFO?» (information) button instead of the ?«SET?» (setting). |
Setting the clock. Press and hold the ?«CLOCK?» (hours), until you hear a short beep. The display indicator lights "12Nr" or "24Nr" corresponding 12 and 24-hour time display mode. Click on the button ?«SET?», to switch the 12 and 24-hour time display modes. This selected mode indicator flashes. In order to select the desired time display mode, press the ?«CLOCK?» (clock) again while the selected mode indicator continues to flash. Then the indicator lights ?«Hr. ADJUST ?»(Set the current time - the clock), and the two left discharge (hours) will flash. Press ?«SET?» set the required indication of the current time in the two left digits (hours), and then press the ?«CLOCK?» (hours). Then the indicator lights ?«Min. ADJUST ?»(Set the current time - a minute), and two right discharge (minutes) will blink. Press ?«SET?» set the required indication of the current time in the two left digits (hours), and then press the ?«CLOCK?» (hours).
Change the clock. During the display of the current time, click on the button ?«SET?» and hold it for at least one and a half seconds. When you release the button, you will hear a short beep, and the clock change. For example: 12: 01-12: 29-12: 00 12: 30-12: 59-1: 00
NOTE When you release the button ?«SET?» reset discharge occurs seconds. |
| 
