 printable version
The index of temperature of the ambient air
System Manual microclimate. The display shows the ambient temperature when the ignition switch is in the ?�ON?� (ignition on).
The automatic climate control.
If the ignition switch is in the ?�ON?� (ignition switched on), in order to display the temperature reading of the ambient air, press the button "AMB" (ambient temperature), which is located on the climate control panel. Click on the "AMB" (ambient temperature) again to switch the display to indicate the temperature of the air in the passenger compartment that is set for the climate control system (Fig. 1.96). In some cases, the thermometer of the ambient air may be different from the actual temperature (depending on the ambient conditions and the state of the car): - Very low or high temperatures; - Sharp change of the ambient temperature; - The vehicle is stationary; - The vehicle is moving at a low speed.
The display of the automatic climate control system. The information display shows information about the current state of the climate control system.
Display Audio. The information display shows information about the current state of the radio.
Trip computer display. Trip computer lets you control the display the following data: - Current fuel consumption; - Average fuel consumption; - Reserve of fuel remaining in the tank; - The average speed of the car.
Current fuel consumption. On the trip computer display shows the current value of the fuel consumption, which is calculated based on the fuel consumption and the distance traveled. Current fuel consumption is calculated and is updated every 2 seconds.
| Fig. 1.97. Displays the current fuel consumption
|
In the indication of the current fuel consumption display indicator lights ?�CONSUM CUR?� (Fig. 1.97). By reducing the speed of the car about 5 km / h readings of the current fuel consumption are replaced by symbols ?�- L / 100 km?�.
Average fuel consumption.
On the trip computer display shows the value of the average fuel consumption, which is taken into account when calculating the amount of fuel consumed and the distance traveled by the vehicle since you last connected the battery to the onboard network, or since the last reset the trip computer. Fuel consumption is calculated and the display is updated every minute. In the display the average fuel consumption on the display will light indicator ?�CONSUM AV?� (Fig. 1.98). In order to remove the trip computer, the displayed, click on ?�INFO?� (information) and hold it down for at least one second. After long pressing the ?�INFO?� (information) on the display shows the symbols ?�- L / 100 km?�, which will remain on display for one minute until a new value is calculated the average fuel consumption.
Cruising on the fuel remaining in the tank. The display shows the approximate distance that can drive a car on the existing fuel in the tank. Reserve calculation is performed based on the average fuel consumption. Cruising range is recalculated and updated every minute.
| Fig. 1.99. Indication of supply of fuel during vehicle
|
In the display fuel range display indicator lights ?�REMNG?� (Fig. 1.99).
NOTE If the trip computer displays evidence of sufficient power reserve until the next refueling, immediately charge the vehicle's fuel tank when the fuel gauge needle in the tank is near the mark "E" (empty) or caught fire alarm minimum fuel. |
Indications on the trip computer display will not change if the tank has been fueled less than 20 ltopliva.
The average speed of the vehicle On the trip computer display shows the value of the average vehicle speed, calculated by distance traveled and time traveled since the last connection of the battery to the onboard network, or since the last reset the trip computer. The value of average vehicle speed is calculated and is updated every 10 seconds.
In the display the average speed of the car on the display will light indicator ?�AV?� (Fig. 1.100).
| 
