printable version
Withdrawal
| Fig. 4.15. The components of the front shock absorber: 1 - a bolt (wheel speed sensor anti-lock brakes); 2 - a bolt (brake hose holder); 3 - a nut (aligning); 4 - bolt (lower part of the shock absorber); 5 - dynamic damper; 6 - fork damper; 7 - a nut (upper part of the shock absorber); 8 - Front shock absorber and coil spring; 9 - a nut of the piston rod; 10 - Rubber Bearing; 11 - Buffer compression stroke; 12 - a protective cover; 13 - coil spring; 14 - Front shock
|
The components of the front shock absorber shown in Fig. 4.15.
ATTENTION Performing the following procedures without first removing the wheel speed sensor anti-lock brake system can lead to chain termination in the harness if the harness is stretched by mistake. Before performing the following operations remove the wheel speed sensor anti-lock brake system (from the hub) and secure it in a suitable place where the sensor is accidentally damaged during maintenance. |
Remove the bolt wheel speed sensor. Remove the bracket bolts of the brake hose. Remove the stabilizer nut and bolt the bottom of the shock absorber. Remove the dynamic damper. Remove the bolt fork damper. Loosen, but do not remove completely the three nuts of the top cover strut. Remove the shock absorber assembly and fix it on a special stand. Close the spring cloth and install special equipment.
Compress the spring with special tool and remove the shock absorber rod nut (Fig. 4.16).
|