add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 626 / MX-6 (from 1982 to 1991, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks
Mazda 626 / MX-6
Home
 
Mazda
626 / MX-6
Operation of the vehicle
Adjustments and service tehnichkskoe
Gas Engines
Diesel engine
System of cooling, heating and air conditioning
The power supply system of petrol engines
Ignition system
The system of emission control
Overview
Electronic Ignition System
Air injection system
System depletion fuel ratio when the vehicle is in neutral gear
PCV
The automatic adjustment of the intake air temperature
Emission at sharp closing throttle
Display System economical mode of motion
Transmission
Brakes
Suspension and steering
Body
Electrical
The device, service and repair later releases
maintenance and repair of cars of release since 1986
Diagrams
 


Hit Counter by Digits


print page printable version

System depletion fuel ratio when the vehicle is in neutral gear



Valve depletion of the fuel mix of idling cars equipped with manual transmission. The valve is designed for additional air into the inlet when the accelerator is released and the overrun, so that the exhaust gases is reduced levels of hydrocarbons and carbon monoxide.
Malfunction of the depletion of the mixture may cause unstable operation and increase the speed of the crankshaft of the engine idling and the continuation of the engine after the ignition is switched off.

Technical condition
Checking the technical condition of the depletion of the fuel mixture when the vehicle is in neutral gear, refer to the section. 2.

Replacement of components
Valve obednitelya
Remove the air filter and remove the wire from the negative battery terminal.
Remove the screws holding the valve obednitelya to the carburetor. Disconnect from the valve plug and move it to the side. Replace the O-ring in place.
Install the new valve in the reverse order of removal.
Switch economizer system overrun
Remove the air filter and remove the wire from the negative battery terminal.
Remove the screws holding the switch to the carburetor. Disconnect the connector from the switch and move it to the side.
Install new switch in reverse order of removal. Before installing the air filter, check the adjustment switch in accordance with the description set forth in Sec. 2.




« previos page
Air injection system
next page »
PCV

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.