printable version
The trunk lid
Open the boot lid and mark the position of the marker nuts hinge lid. Ask two assistants to support the trunk lid open, unscrew the locking nuts and remove the cover from the trunk of the car. Installation is performed in reverse order of removal. With two assistants, set the trunk lid, and from the hand screw lock nuts. Close the lid of the trunk, check its position relative to adjacent surfaces and, if necessary, adjust its position, then tighten the nut.
Lock lid To gain access to the lock, remove the decorative trim panel. On cars with notchback coupe or remove the fuse.
| Fig. 12.5. Elements of fastening of a cable and lock lid: A - model sedan and coupe; B - model hatchback
|
To gain access to the cable drive of the lock, remove the screws and move the lock to the side (Fig. 12.5). Disconnect the cable and traction drive lock and remove the lock from the vehicle. Installation is performed in reverse order of removal.
Impact plate lid To access the shock plate lid, remove the decorative trim panel. Marker, mark the position of the shock bolts of the plate lid. Remove the bolts and remove the strike plate. Installation is performed in reverse order of removal. If necessary, adjust the shock plate. This can be done by tightening or loosening the bolts up until it reaches the desired position tailgate.
The mechanism of opening the tailgate and fuel filler cap In-car access to the bolts fastening the squeezing lever, remove cover, pull tabs and remove the carpet. Remove the bolt and disconnect the cable from the lever. At the rear of the vehicle to access the opening mechanisms remove decorative trim panel. Disconnect the cable from the trunk lock.
| Fig. 12.6. Elements of fastening of a cable to the filler cap: 1 - a nut; 2 - an arm
|
Disconnect the cable filler cap of the bracket and pull the rope to open the lid. Remove the nut and remove the cable (Fig. 12.6). Attach the thin cord to the cable opening of the lid and / or the filler neck and pull the cable into the interior of the vehicle. Power required for drawing of a new cable in place. Tie the string to a new rope and retract it into place. Further installation is carried out in reverse order of removal.
|