REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Nissan Almera (from 1995 to 1999, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Nissan
	Almera
		General Information
		General requirements for car repair
		Operation and maintenance of car
		Petrol engines
		Diesel engines
		Transmission
		Chassis
		A steering
		The brake system
		Electrical
		Body
			Basic information
			Body repair
				Removing and installing bonnet
				Removing and installing front bumper
				Removing and installing rear bumper
				Removal and installation of a forward wing
				Removing and installing the front and rear doors
				Removing and installing front door trim
				Removing and installing rear door trim
				Removal and installation of windows front and rear doors
				Removal and installation of the outside door handle
				Removing and installing door locks
				Removal and installation of glass
				Removing and installing tailgate (body type hatchback)
				Removing and installing rear lid (sedan type)
				Removal and installation of the instrument panel
			Heating and ventilation system
			Climate control (air conditioning)
			The system of airbags and seat belt pretensioners
		Applications
		Scheme of electrical equipment

printable version

Removal and installation of windows front and rear doors

Fig. 9.25. Details of windows: A - windows with manual transmission; B - power window; B - the back door; T - the front door; 1 - frame glass; 2 - glass; 3 - run channel; 4 - loop; 5 - Limiter door opening; 6 - power window; 7 - window handle; 8 - Manually operated windows; 9 - rear fixed window; 10 - fixed glass frame

Details of the mechanism and the rear window of the front door shown in Fig. 9.25.

Fig. 9.26. Details of doors: And - the front door; B - the back door; 1 - bolt electric window motor; 2 - bolts guide resistant glass; 3 - bolts of the adjusting device door lock actuator; 4 - a bolt of fastening of the internal handle lock actuator; 5 - bolts rear guide groove; 6 - bolts sliding window to the holder; 7 - the bolts of the side doors of the amplifier

Remove the door trim (see. Above). Remove the sealing plate. On vehicles with electric windows temporarily Dock connector, and set the glass so that you can see the screws 6 (Fig. 9.26) fastenings to lowered glass cage Remove the screws and adhesive tape fix the glass in this position. At the front door, remove the side plate of the amplifier. Turn out bolts of mechanical window and remove it. On cars with power windows, remove the bolts of the motor to the drive window, after disconnecting the electrical connector.

Install window procedure in the reverse of its removal.

« previos page
Removing and installing rear door trim

next page »
Removal and installation of the outside door handle