 printable version
Removal and installation of the system
Removal and installation of the system The front part of the exhaust system of a vehicle with an engine SR20DE The front part of the exhaust system of the carburettor engine The rear part of the exhaust system Obviously, the exhaust system in this guide models have different designs, so that we confine ourselves to the description of the model catalyst. On models without a catalyst, the latter is replaced by a silencer. On the graphics front part of the exhaust system of a vehicle with an engine SR20DE and front part of the exhaust system of the carburettor engine shows the front part of the exhaust system of the injection and carburetor engines. In the shows the rear part of the system, which with a few differences practically the same for all models. However, the location and securing the back of a little different, what you quickly make during the inspection of the installed system. Guided by these illustrations do the following work: | - Prop up the system from the bottom to the suspension has been weakened.
- Loosen the screws on the underside of the exhaust manifold and remove the exhaust front pipe from the manifold. Depending on the performance of the collector attached single or double reception pipe.
- Unscrew all heat shields with the lower side of the exhaust system.
- Remove the nut and bolt to disconnect the tube from the metal bracket.
- Remove the oxygen sensor from the exhaust front pipe, when it comes to fuel-injected engine.
- Remove the bolts and remove the suspension of the muffler.
- To remove the front portion of the system, remove the nut, remove the screws from the top and remove the tube from the catalyst.
- To remove the back part of the system, remove the nuts and loosen the rubber suspension. If you want to remove only the main silencer and / or the tube, remove the fasteners according to
and unscrew the pipe back on the connecting flange of the muffler or a catalyst. In the non-catalytic medium is disposed between the main pipe and the muffler pipe and reception must be attenuated accordingly.
- Dismantle the system as required, if the system has been removed in the kit and insert new items.
- When installing the components described, consider the following, if the entire system is replaced by:
- All torques shown in the accompanying illustrations.
- Gasket between front exhaust pipe and catalyst, the reverse side of the catalyst and the rear pipe rear muffler pipe and always replace the main, even if they have even a satisfactory appearance. In an extreme case, you can set the old gasket in good condition with the help of the sealant.
- Watch for sufficient distance between the elements of the exhaust system and other parts of the body.
- Screw the oxygen sensor in the exhaust pipe and torque to 18-24 N ??? m. After installation, check all the rubber parts. They should not be stretched as otherwise burst after a short time.
- Install any suspension in accordance with the wiring diagram.
|
|
|
