1. Remove the rear brake to the hub. |
2. Install the trailing arms on the support beams. |
3. To raise and establish on support a back part of the car. |
4. Raise slightly trailing arm beams in the area of fastening of a wheel, making sure that the car does not fell off the supports. |
5. Remove the screw 2 (see. Fig. Shock absorber lower mounting) while holding the nut wrench. |
6. Lower the trailing arm beam as low as possible and remove the shock absorber. |
7. Remove the pressure regulator (see. Subsection 10.6), if installed. |
8. Disconnect parking brake cables (see. Subpart 10.12). |
9. To establish a support beam 11 (see. Fig. Rear axle) rear suspension. |
10. Remove bolts 10. |
11. Remove the rear axle. |
12. Drive out the sleeve 6 of the bracket beams. A warning If you need to remove an arm 9 with the body, you must first cut around its outline on the body for further accurate installation bracket.
|