printable version
Parking brake
Parking brake
1 - an arm; 2 - the switch; 3 - the screw; 4 - gear sector; 5 - shaft; 6 - dog; 7 - a spring; 8 - button; 9 - pusher; 10 - the handle; | 11 - the parking brake lever; 12 - lock nut; 13 - an adjusting nut; 14 - bracket; 15 - housing; 16 - stopper; 17 - a shaft; 18 - threaded end of a rope; 19 - Case |
Fixing the parking brake cable sheath
Parking brake cord, disc brake
Withdrawal Setting
Install the parking brake cable is carried out in reverse order, followed by adjust the parking brake (see.
Parking brake cord, drum brake Withdrawal
Setting
Install the parking brake cable is carried out in reverse order, followed by adjust the parking brake (see.
Adjusting the parking brake
PERFORMANCE ORDER | 1. To raise and establish on support a back part of the car. | 2. Remove the cover 15 (see. Fig. The parking brake). | 3. Loosen the lock nut 12 and the adjustment nut 13 threaded lugs both ropes. | 4. Press hard on the brake pedal. | 5. Tighten the parking brake lever in the two mouse models of release till December, 1987, or four clicks in models produced after January 1988 | 6. Tighten the adjusting nuts 13 to the time when there will probably rotate the rear wheels by hand. | 7. Release the parking brake and check turn freely both wheels. If not - let go a little adjusting nuts 13. | 8. Tighten the locknut 12, while holding the adjusting nuts 13. | 9. Install the cover 15. |
|
|