add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Passat B6 (from the year 2004)

general info. full specifications. diagnostics. hints. tips. tricks
Volkswagen Passat B6
Home
 
Volkswagen
Passat B6
Operation and maintenance of car
Engine
Overview
Mechanical (engine capacity of 1.6 liters)
Lubrication system
Cooling system
Fuel Injection System
The mechanical part (petrol engines of 2.0 liters)
Lubrication system
System ohlazhdeiya
Fuel system
Removal of the fuel from the fuel tank when filling the fuel tank more than 3/4
Pumping of fuel from the fuel tank is less than 3/4
Check the functioning and power
Checking fuel pressure
Check of residual pressure
Performance Verification
Electronic control of engine power (electronic throttle actuator)
Removal and installation of the accelerator pedal assembly
Absorber
Check pumping fuel tank
Injection system
System of release of gases otrabotavschih
Ignition system
The mechanical part (diesel engines of 2.0 liters)
Lubrication system
Cooling system
Fuel system
Turbocharging turbo running on exhaust
The direct injection diesel
Exhaust
Tables
Transmission
Chassis
Steering Gear
Brakes
Onboard electric
Body
diagrams
 


Hit Counter by Digits


print page printable version

Removal and installation of the accelerator pedal assembly



Removing the accelerator pedal assembly

Cover the steering column
Fig. 2.214. Cover the steering column


Remove the cover of the steering column (Fig. 2.214).
Pry up the cover with a screwdriver.
Remove the retaining screw.

Set Lock Picks
Fig. 2.215. Set Lock Picks


Insert as shown in Figure 2.215, all the way into the holes and remove the accelerator pedal assembly.
Disconnect the electrical connector and release the cable from the pedal assembly.

Installation of the accelerator pedal assembly

The scheme of installation of the accelerator pedal assembly
Fig. 2.216. The scheme of installation of the accelerator pedal assembly


Insert tab of the guide wire 1 and 2 to connect the connector assembly of the accelerator pedal (Fig. 2.216).
Install the accelerator pedal mounting bolts 6.
Insert the centering pin 7 in the hole in the bottom.
Screw the accelerator pedal assembly bolt 3 with a torque of 10 Nm.
Push the cap 4.
Install the steering column trim.




« previos page
Electronic control of engine power (electronic throttle actuator)
next page »
Absorber

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.