 printable version
Removal and installation of the lower control arm
Withdrawal Measure the distance from the wheel center to the edge of the wheel arches. Remove the wheel. Remove the coil spring.
Vehicles with dynamic headlight range control Remove the tie-rod rear left vehicle level sensor.
Continuation of the assembly operations for all vehicles Note, for example, felt pen, the position of the eccentric relative to the subframe bolts. Remove and lower the rear part of the exhaust system. Remove the bolt. Remove the lower wishbone.
Setting Insert the lower wishbone in the car and tighten the screws by hand. Screwed wishbone should only be achieved when the size of ?�a?�. Screw the lower wishbone on the subframe and tighten the new nut to the specified torque. Note the labeling provisions in respect of the eccentric bolt the subframe. Install the back part of the exhaust system.
Vehicles with dynamic headlight range control Install the connecting rod Geber für Fahrzeugniveau HL.
Continuation of the assembly operations for all vehicles Tighten the bolt of the lower arm 1. Install the coil spring. Install and tighten the wheel. Adjust the wheel alignment.
| 
