 printable version
Repair trailing arm
Pulling out the rubber sleeve Remove the trailing arm.
Hold the trailing arm in a vise so that the support bracket 1 touched the grip (Fig. 4.71). Remove the bolt 2.
| Fig. 4.78. Installation tools: 1 - the tube; 2 - mandrel; 3 - A tool for pulling out; 4 - the pressure plate; 5 - the pushing plate
|
Install tools, as shown in Figure 4.78. Extract the rubber-metal sleeve.
Pressing the rubber sleeve Put the trailing arm on a flat surface.
| Fig. 4.79. Install the trailing arm on the plane
|
Install the trailing arm on the plane so that the size and was equal to 113 mm (Fig. 4.79). Mark a vertical line on the trailing arm bushing.
Place the rubber-metal sleeve on the trailing arm so that the marked line is between the protrusions 1 (Fig. 4.80).
NOTE Watch out for the correct mounting position of the rubber bushings of the trailing arm relative to the sleeve. |
| Fig. 4.81. Installation tools: 1 - the tube; 2 - pressing plate; chamfer should be directed to the rubber bushing; 3 - Anti-sleeve; 4 - a tool for pressing out; 5 - the pushing plate
|
Press in rubber-metal sleeve flush. Install the support bracket to the trailing arm. Install the trailing arm.
| 
