add to favorites

REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Passat B6 (from the year 2004)

general info. full specifications. diagnostics. hints. tips. tricks

Volkswagen Passat B6

Home

Volkswagen
	Passat B6
		Operation and maintenance of car
		Engine
			Overview
			Mechanical (engine capacity of 1.6 liters)
			Lubrication system
				Removing and installing oil pan
				Removal and installation of the oil pump
			Cooling system
			Fuel Injection System
			The mechanical part (petrol engines of 2.0 liters)
			Lubrication system
			System ohlazhdeiya
			Fuel system
			Injection system
			System of release of gases otrabotavschih
			Ignition system
			The mechanical part (diesel engines of 2.0 liters)
			Lubrication system
			Cooling system
			Fuel system
			Turbocharging turbo running on exhaust
			The direct injection diesel
			Exhaust
			Tables
		Transmission
		Chassis
		Steering Gear
		Brakes
		Onboard electric
		Body
		diagrams

Hit Counter by Digits

printable version

Removal and installation of the oil pump

Withdrawal

Remove the oil pan.

Hold the oil pump sprocket wrench to lock.

Loose sprocket

Fig. 2.56. Loose sprocket

Loosen the bolt with an asterisk (Fig. 2.56).

NOTE

Fully unscrew the bolt.

Pressing on the tensioner

Fig. 2.57. Pressing on the tensioner

Use a screwdriver to push the chain tensioner in the direction of the arrow (Fig. 2.57).

Remove the chain tensioner mounting bolt.

Remove the asterisk from the oil pump and remove it from the chain.

Bolts of fastening of the oil pump

Fig. 2.58. Bolts of fastening of the oil pump

Loosen the oil pump bolts and unscrew them (Fig. 2.58).

Remove the oil pump from the cylinder block.

Setting

Use a screwdriver to push the chain tensioner in the direction of the arrow (Fig. 2.57).

Insert an asterisk to the circuit and push on the oil pump shaft.

The correct position of the stars

Fig. 2.59. The correct position of the stars

Check the position of the stars on the oil pump shaft (Fig. 2.59).

Screw the mounting bolt of an asterisk.

Hold the asterisk key to lock.

Installation of a torque wrench

Fig. 2.60. Installation of a torque wrench

Place the torque wrench (5-50 Nm), as shown in Figure 2.60.

Tighten the fixing bolt with a torque of 20 Nm + 1/4 turn (90 ?�).

Install the oil pan.

« previos page
Removing and installing oil pan

next page »
Cooling system

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.