add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Passat B6 (from the year 2004)
general info. full specifications. diagnostics. hints. tips. tricks
 Volkswagen Passat B6
Home
 
Volkswagen
Passat B6
Operation and maintenance of car
Engine
Transmission
Chassis
Steering Gear
Brakes
Onboard electric
Overview
Power supply system
Generator
Removal and installation of a three-phase generator, the engine of 1.6 liters with injection
Removing and installing poly V-belt pulley without freewheel
Removing and installing ribbed belt pulley with freewheel manufacturer Bosch
Removing and installing voltage regulator manufacturer Bosch
Removing and installing starter (vehicles with engine 1.6 liter FSI, automatic gearbox)
Removing and installing starter (vehicles with 1.6-liter engine with fuel injection, manual gearbox)
Removing and installing starter (vehicles with engine 2.0 liter TDI, gearbox with dual-clutch (DSG))
Lighting
Body
diagrams
 


Hit Counter by Digits


print page printable version

Removing and installing starter (vehicles with engine 2.0 liter TDI, gearbox with dual-clutch (DSG))



Withdrawal
Disconnect the battery.
Pulling up, remove the engine cover

Connector, spring clamp and a vacuum hose
Fig. 7.37. Connector, spring clamp and a vacuum hose


Disconnect the connector 1, open the spring clamp 2 with a pair of pliers for spring clips and remove the vacuum hose 3 (Fig. 7.37).

Fixing bolt of the air filter housing
Fig. 7.38. Fixing bolt of the air filter housing


Remove the retaining bolt of the air filter (Fig. 7.38).

Cover
Fig. 7.39. Cover


Unlock the tabs and remove the cover (Fig. 7.39).

The hose of the air filter
Fig. 7.40. The hose of the air filter


Remove the hose from the air filter housing and remove the hose (Fig. 7.40).
Pull air filter housing upwards from the anchorage and remove it.

Protective cap traction relay
Fig. 7.27. Protective cap traction relay


Slide the cap in the direction of the arrow with the traction relay (Fig. 7.27).

The connector terminal 50
Fig. 7.28. The connector terminal 50


Remove the positive cable 1 and disconnect the connector terminals 50 2 (Fig. 7.28).

Upper mounting bolt starter
Fig. 7.41. Upper mounting bolt starter


Remove the upper starter mounting bolt (Fig. 7.41).

Lower mounting bolt starter
Fig. 7.42. Lower mounting bolt starter


Remove the lower starter mounting bolt (Fig. 7.42).
Remove the starter from the engine compartment by lifting it up.

Setting
Installation is performed in reverse order, with the following should be considered.
Tighten to the specified torque.

Torque (starter)




« previos page
Removing and installing starter (vehicles with 1.6-liter engine with fuel injection, manual gearbox)		 next page »
Lighting

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.