 printable version
Valves
The engine capacity of 2.0 liters
A warning  If items control valve will be used again, they must be installed in its place. To avoid confusion of parts, fabricate panel for storage.
Withdrawal
| PERFORMANCE ORDER | | 1. Remove the cylinder head and place on wooden slats so that the valves are supported from below. | | 2. Remove the valve stem seals. | | 3. Fold in the side of the cylinder head and remove the valve from the guides. | | 4. Clean the valves. |  | 5. Valves Burned plates, with too small height (h) of the valve disc, worn or scratched rods should be replaced. The limit value (h) cm. Table sizes of valves. |  | 6. Repair shop can check the valve stem to the beating and make revision angle bearing surface of the valve. Maximum run-out valve stem and valve seat: 0.03 mm. |
|
A warning
 | In all processing operations of valves should be borne in mind that the angle of the valve disc is a = 45 ?° + 15 ?°. |
Note: The valve stem core and engine capacity of 2.2 / 2.5 L 3 have the ring groove.
Setting
| PERFORMANCE ORDER | | 1. Before installing the check valve and the valve guide, if necessary, modify the valve seat. | | 2. Strip the valve stem in place fit stock items. | | 3. Lightly lubricate the valve stem and the valve guide with engine oil and install valve. | | 4. Install new valve stem seals. | | 5. Install the valve spring. | | 6. Set all valves, not to confuse the intake and exhaust valves. | | 7. Set the bucket tappets. | | 8. Install the cylinder head. |
|
Valve sizes
INTAKE VALVE (195) | Drain valve (196) | Engines 2.0-liter | D = 37,9 - 38,1 mm | D = 34,9 - 35,1 mm | D1 = 7,97 - 7,955 mm | D1 = 8,960 - 8,945 mm | L = 106,4 mm | L = 106,4 mm | h (new) = 1.75 - 2.05 mm | h (new) = 1.75 - 2.05 mm | h (the limit). = 1.6 mm | h (the limit). = 1.6 mm | Engines of 2.2 / 2.5 L | D = 29 mm | D = 26 mm | D1 = 6 mm | D1 = 6 mm |
|
