 printable version
Overview
Body include crumple zones at the front and rear collision with safety cell in the center of the car. Almost all of the components and equipment parts of the body can be installed and removed with the usual set of tools. When disassembling and assembling the need to take special precautions not to damage the sealing and anti-corrosion coating applied at the factory. Body repair is recommended in special workshops, where they can replace the bolts fastened fenders, front fascia, doors, hood, trunk lid and large panel - roof and sidewalls. Before working on the instrument panel, doors, or any electrical device, remove the wire of "weight" from the storage battery. During welding and other work related to the strong iskrovydeleniem near the battery, be sure to remove the battery. It is forbidden to carry out welding, hard and soft soldering parts filled the air conditioner. This also applies to those components of a vehicle, welding, which can cause heating of the air-conditioner parts. When carrying out repair and painting works in the dryer or in the zone of its heating temperature should not exceed +80 ?� C. Checking the condition of the body must be carried out regularly. Otherwise corrosion of separate parts of the body can lead to severe damage in the future costly repairs. It is also important to pay attention to inaccessible parts of the external look of the car, such as the bottom, wheel arches and the bottom of the engine compartment, as well as parts of the body, hidden under the upholstery. The main element in the care of the body is its sink. Before a car sink soak insects and remove from the surface of the body. Liberally use water. Use a soft sponge or a soft brush. Varnish can not be washed with high-pressure jet. Pour over the car from a hose and wash off dirt from the top down. Frequently rinse the sponge. Wipe the vehicle with a clean cloth. Apply only good degreasing washing substances. In order to protect the water for a sink add washing preservatives. Do not wash the car and dry in the sun, otherwise on a varnish surface there are stains. Salt which strew roads, has harmful effects on the body of the car.
WARNINGS Before disconnecting the wire of "weight" from the battery, make sure you know the correct code of the receiver, which restores its efficiency. If the connecting wire of "weight" to enter the wrong code, the receiver turns off. In order to maintain the connection with "weight" and prevent damage due to corrosion, do not disconnect the wires from the body. Disconnect the wires from the battery only, the engine or transmission. Before connecting the wires, strip all contacts. Ensure that the connection with "weight". |
|
