 printable version
Cylinder head cover
A WARNING All clips and clamps that when removing the cylinder head cover are damaged or cut, the assembly must be replaced with new ones. |
Withdrawal Switch off the ignition and disconnect a wire of "weight" from the storage battery.
| Fig. 3.3.2. Location engine cover screws and the pointer (1) engine oil level
|
Release clamps fastening, remove the three screws and remove the engine cover (see. Fig. 3.3.2). Install the engine oil dipstick in place.
| Fig. 3.3.4. Location bolts of air nozzles (1 and 2)
|
Remove the bolts and remove the air tubes 1 and 2 (see. Fig. 3.3.4).
Cars with engines AJM
| Fig. 3.3.34. An arrangement of bolts (1 and 2) mounting clips secondary cooling system hoses and clamps the upper toothed belt
|
Remove bolts 1 and 2 (see. Fig. 3.3.34) mounting clips secondary coolant hoses and, without disconnecting hoses, take them aside.
All models
| Fig. 3.3.43. Sequence of a tightening of bolts fastening the cylinder head cover and place the crankcase ventilation hose connection
|
Disconnect the crankcase ventilation hose from the cylinder head cover (see. Fig. 3.3.43). In sequence, return to a tightening, loosen the screws cylinder head cover (Fig. 3.3.43).
Setting Installation is spent to sequences, return to removal, taking into account the following. If necessary, replace the gasket cylinder head cover. Degrease, gasket cylinder head cover. Apply a layer of sealant at the interface planes in the semi-circular surface on both sides of the cylinder head. Install the cylinder head cover and screw bolts, tightening them by hand In the sequence shown in Fig. 3.3.43, tighten the bolts of the cylinder head to 10 Nm.
| 
