 printable version
Cylinder ignition
Withdrawal Set the wheels of the car to move straight ahead. Remove the steering column switch.
| Fig. 18.58. Cylinder ignition 1 - the electrical connector; 2 - the ignition lock; 3 - column cover; 4 - an electric socket pickup coil the immobilizer; 5 - the screws
|
Disconnect the electrical connector 4 (Fig. 18.58) from the pickup coil the immobilizer. The arrow shows the direction of removal of ignition.
Cars with automatic transmission Move the selector lever in position ?�P?�.
| Fig. 18.59. Key positions (A, B, C) when removing the ignition and the location of the lever (1) and cable (2) ignition
|
Turn the ignition key to position B (?�Ignition on?�) (Fig. 18.59). Remove the lever 1 and remove the ignition cable 2, pull it from the chassis ignition.
All models To perform the following steps to remove the ignition cylinder ignition need a flat handle (without light or remote control transmitter). Insert the key into the ignition and turn it to the ?�Ignition on?�, in this case should be seen in the opening end of the cylinder ignition.
| Fig. 18.60. Removing the cylinder ignition: A - hole for mounting the ignition; B - direction of removal of the ignition lock cylinder
|
Insert a steel rod with a diameter of about 1.5 mm into the hole until it stops and remove the cylinder from the readout from the housing ring ignition (Fig. 18.60).
Setting Insert the key into the ignition and turn it to the ?�Ignition on?�. Insert a steel rod with a diameter of about 1.5 mm up to the stop in the hole and install the cylinder in the ignition housing. Press all the way on the cylinder lock with a key. Remove the steel bar and click on the lock cylinder until it engages the latch. Install the steering column switch.
| 
