 printable version
Electronic engine control unit
Withdrawal Electronic engine control unit is located in plenum front of the windshield. Remove the rubber seal waterproof housing at the rear of the engine compartment.
| Fig. 18.5. The direction of removal of the rubber seal waterproof casing: 1 - waterproof casing
|
| Fig. 18.6. Location latches securing the cover of the electronic engine control unit
|
Blade screwdriver to release clamps (Fig. 18.6) securing the cover of the electronic engine control unit and remove it. Blade screwdriver to release clamps of fastening of the electronic engine control unit and lift the unit.
| Fig. 18.7. Directions weakening clamp electrical connectors (1 and 2) electronic engine control unit
|
Loosen the clamp and disconnect the unit from the power connectors 1 and 2 (Fig. 18.7). If you have a disconnect an electric socket from a height sensor. Blade screwdriver to release the lock and lift up an additional block of the relay located in the box for the electronic engine control unit. Disconnect the electrical connectors on the rear connector block and remove the engine wiring harness together with the sealing ring out of the box of the electronic engine control unit. Remove the nut and bolt and remove the box ECU.
Setting Installation is performed in reverse order of removal. When installing the boxes ECU Check the installation gasket box.
| 
