printable version
Removal and installation of glass tailgate
Withdrawal
| Fig. 8.39. Connector wires of the rear window
|
Disconnect the wiring connector of the rear screen (Fig. 8.39). Remove the lining of the tailgate. Remove the lever and the wiper motor. Remove the third brake light.
NOTE The procedure for removing the rear windscreen and the same. |
Setting With a cutter or accessories 09861-31200 exactly cut the bead of adhesive to a thickness of about 2 mm from the surface of glass sticking out around the perimeter of the flange opening.
ATTENTION Do not cut the glue roller to a thickness less than this, and take precautions not to damage the paintwork of the body cutter. When you restore the damaged layer, causing topcoat. |
Clean the flange opening rear window with a sponge soaked in alcohol, or a mastic and degreasing. Install the new rear glass opening and a soft pencil put labels on the glass and the body in four places. Install cover rear window, making sure that there are no gaps. Apply a thin layer of adhesive primer for glass on the edge of the rear window.
Apply a thin layer of adhesive primer for the body on the left on the flange opening glass sealant. After application of the adhesive ground glass set, no later than 5 minutes. With suction cups 09861-31400 apply to the rear window opening, combining labeling and push the glass to the layer of sealant. Remove excess glue with a spatula, or wipe it with gauze. Fill all voids with adhesive around the perimeter of the glass. Ensure integrity of the windscreen, which pour its stream of cold water, taking care to not damage the strong stream of fresh adhesive. Watering so that water flowed along the edges of the glass. If you find leaks dry place and apply sealant leakage. Install the previously removed parts.
|