Removal and installation of components of the rear passenger door

Remove the screw interior trim door handles (Fig. 8.21).

Remove the screws holding the door trim panel (Fig. 8.22).

Install the puller flap between the bindings and trim guard the door and remove the shield. Remove the wire connectors from the rear door (Fig. 8.23).

Remove the vapor barrier doors (Fig. 8.24).

Lower the rear door glass and then remove the bolts holding the rear door glass.

Remove the front glass run channel rear door (Fig. 8.25).

Remove the rear door glass of a back door modules (Fig. 8.26).

Remove the rear door glass and loosen the bolts holding the rear glass run channel back door.

Remove the rear glass run channel rear door (Fig. 8.27).

Remove the fixed glass.

Remove the stem from the external handle.

Remove the clip, cable harness and module rear door.

Setting

Installation is the reverse order of removal.

When installing a vapor barrier doors, butyl tape should not block the openings of fastening the door trim.