 printable version
Wiper switch and windshield washer
The switch has three positions: 1. Intermittent; 2. Slow motion; 3. Rapid movement.
| Fig. 1.49. Modes of operation and windscreen wiper
|
NOTE To prevent damage to the windshield wipers do not try to clean up their heavy precipitation in the form of snow or ice. The accumulated snow or ice clean by hand. If there is only a small layer of snow or ice, turn on the heater in the heating mode of the windscreen and melt snow or ice before using the wipers. |
Automatic activation of windscreen wipers (optional)
| Fig. 1.50. Automatic activation of windscreen wiper
|
When the windshield wiper switch is set to ?�AUTO?�, the sensor "rain" at the top of the windscreen detects the amount of rainfall and automatically selects the interval wiper operation (Fig. 1.50).
NOTE After clearing the accumulated snow or ice from the windscreen wait 10 Mindl more accurate sensor operation "Rain" (Fig. 1.51). |
ATTENTION When the ignition key is in the ?�ON?�, a windshield wiper switch in position ?�AUTO?�, wipers can automatically resume work and injure your hands. Do not touch the top of the area of the windshield where the sensor is "rain." Do not wipe the upper part of the windscreen with a cloth. Do not press down on the windshield. |
Job Windshield Washer
Washer fluid is supplied to the windshield when the lever switch wiper / washer towards the steering wheel. When the windshield washer simultaneously with the cleaning liquid wipers automatically will make two turns (Fig. 1.52). Washer stops working when the switch wiper / windshield washer released.
NOTE Do not operate the washer for more than 15 seconds, or when the washer reservoir is empty. In cold weather, before using the wiper, make sure the wiper blades are not frozen to the glass. In areas where water freezes in winter, use antifreeze fluid for washing the windshield. |
Demisting the windscreen
For demisting the windscreen (for windscreen wiper single) pull up the switch wiper / windshield washer (Fig. 1.53).
Wiper with variable interval mode wiper (optional)
| Fig. 1.54. Wiper with variable interval mode wiper
|
To use the mode of operation of the wiper blades with a variable interval, move the wiper switch to the position ?�INT?� (?�Intermittent") (Fig. 1.54). In this position, the switch interval intermittent operation of the wiper blades can be changed in the range from 1 to 18, by turning the adjusting wheel on the stalk. The interval is selected depending on the vehicle speed.
Windshield wiper and washer, rear window (optional)
| Fig. 1.55. The inclusion of a screen wiper and rear window washer
|
1. The cleaning fluid is supplied to the rear window and the wiper operates when the tip of the lever switch is in this position. 2. In the position ?�ON?� rear window wiper operates continuously. 3. After the fluid on the rear window wiper is activated 2-3.
NOTE Do not operate the washer for more than 15 seconds, or when the washer reservoir is empty: it can damage the system. Do not operate the wiper on a dry glass; this can cause scratches on the glass, or premature wear of the wiper blades. For the same reasons, do not turn on the wiper when the washer reservoir is empty. |
| 
