|
|
 printable version
Ignition coil
Check voltage
| PERFORMANCE ORDER | | 1. Disconnect the negative battery terminal. | | 2. Disconnect the connector from the ignition coil. | | 3. Turn the ignition switch to "ON". |  | 4. Measure the voltage between the blue and green wires in the connector of the ignition coil. Voltage: 12 V | | 5. If there is no voltage, check the fuses, ignition switch and wiring harness. |
|
Check resistance
| PERFORMANCE ORDER |  | 1. An ohmmeter to check the resistance of the primary winding of the ignition coil. Connect one ohmmeter test lead to the positive (+) terminal and the other probe to each negative (-) terminal. If the resistance is not correct, replace the ignition coil. Remember that the unit has two coils, the resistance of which must be checked. Primary resistance: 0.45-0.55 ohms at 20 ?� C |  | 2. By an ohmmeter to check the resistance of the secondary winding of the ignition coil. If the resistance is not correct, replace the ignition coil. Secondary resistance: 13-15 ohms at 20 ?� C |
|
Withdrawal | PERFORMANCE ORDER | | 1. Disconnect the negative battery terminal. | | 2. Disconnect the high-voltage wires. | | 3. Disconnect the connectors from the ignition coil. | | 4. Remove the four screws on the ignition coil. | | 5. Remove the ignition coil. |
|
Setting | PERFORMANCE ORDER | | 1. Install two ignition coils on the spark plugs of cylinders 2 and 4, and then click on them to join. | | 2. Replace the four screws on the ignition coil. Torque: 19-25 N ??? m | | 3. Connect the connectors to the ignition coil. | | 4. Connect the high-voltage wires. | | 5. Connect the cable to the negative terminal of the battery. |
|
|
|
