add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 3 (2003 release)
general info. full specifications. diagnostics. hints. tips. tricks
 Mazda 3
Home
 
Mazda
3
Operation and maintenance of car
Engine
Transmission
Chassis
Steering Gear
Brakes
Overview
brake system
Check and adjust the braking system
Checking the brake fluid hydraulic drive braking system
Removal of air from brake system
Check the check valve vacuum hose (brake booster)
Removal and installation of the vacuum hose (brake booster)
Removing and installing brake pedal
Removal and installation of the main brake cylinder
Withdrawal
Setting
Check the fluid level sensor
Removing and installing brake servo
Check the brake servo
Dismantling and assemblage of the master cylinder
Removing and installing front brake disc
Replacing the front brake pads
Removing and installing rear disk brake
Checking the parking brake system
Removal, check and installation of the rear wheel speed sensor ABS
Removal and installation of the hydraulic unit Anti-lock brake system
Tables
Onboard electric
Body
 


Hit Counter by Digits


print page printable version

Withdrawal



ATTENTION
Do not spill the brake fluid on the painted surface. If you get brake fluid on the painted surface, wash it off immediately.

Drain the brake fluid.
Disconnect the connector brake fluid level.
Disconnect the brake magastral disconnect brake tubes from the main brake cylinder.

Detach the hose from the brake fluid reservoir
Fig. 6.23. Detach the hose from the brake fluid reservoir


Disconnect the hose from the brake fluid reservoir by pressing in the point indicated by the arrow (Fig. 6.23).
Remove the two nuts, remove the choke, brake master cylinder and the gasket.




« previos page
Removal and installation of the main brake cylinder		 next page »
Setting

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.