REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 6 (2002 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mazda
	6
		Operation and maintenance of car
		Engine
		Transmission
		Chassis
		Steering Gear
		Brakes
		Onboard electric
		Body
			Overview
			Air conditioning and heating
				Air filter
				Block the air conditioning system
				Evaporator
				Expansion Valve
				Capacitor
				Control system
				Air conditioner control unit
				Check heat exchanger
				Removing and installing rear duct
				Removal and installation of the air conditioning system compressor
				Dismantling and assembling freewheel
					Remove the bolts freewheel
					Adjusting freewheel
					Checking freewheel
				Care of the car body

printable version

Adjusting freewheel

Fig. 8.94. Measurement circumferential gap between the pressure plate and the compressor pulley

Measure the circumference of the gap between the pressure plate and the pulley of the compressor air conditioning systems using a thickness gauge (Fig. 8.94).

Make sure that the gap is correct.

Fig. 8.95. Installing a new gasket between the pressure plate and the compressor pulley

If not, remove the pressure plate and adjust the clearance selection laying 0.2-0.5 mm or more spacers (Fig. 8.95).

« previos page
Remove the bolts freewheel

next page »
Checking freewheel