 printable version
Removing and installing selector lever
| Fig. 3.88. The switching mechanism of an automatic transmission 1 - facing the steering column (with a key locking mechanism); 2 - clip (key interlock mechanism); 3 - clip (key interlock mechanism); 4 - a cable lock (with the key interlock mechanism); 5 - a cable of a choice of transfer; 6 - the selector lever valve
|
The switching mechanism of the automatic transmission shown in Fig. 3.88. Disconnect the negative battery cable. Remove the battery and battery tray. Remove the air filter. Remove the console. Remove the dashboard. Remove the control module stability control system.
| Fig. 3.89. Removing the air conditioner control unit: 1 roping choke; 2 - unit air conditioner unit
|
Remove the rear duct. Remove the steering column trim. Remove the clips and remove the cable lock and a cable gear selection.
NOTE Installation is carried out in the manner indicated in Figure 3.88. Specific procedures for removal and installation described in this section. |
| Fig. 3.90. Driving gear selection cable installation
|
To install a cable of a choice of transfer, you must first install it on the bracket, as shown in Figure 3.90. Before replacing the gear selection cable, check that the selector lever is in position P.
| Fig. 3.91. Lock cable lock gear selection (by the selector lever)
|
Lock the cable lock gear selection (by the selector lever) in the order shown in Figure 3.91.
ATTENTION When installing the gear selection cable, hold it straight. Kinking rope gear selection, as shown in Figure 3.92, will result in damage to the cable, it can cause a weakening of the cable when switching. |
| Fig. 3.93. Proper installation of the lever of the selector lever on the manual shift shaft
|
NOTE Set the selector lever on the manual shift lever shaft so that the spring tip gear selection cable is facing toward the front of the vehicle (Fig. 3.93). |
Set the selector lever on the manual shift lever shaft so that the gear selection cable was not loaded. Make sure that the end of the lever of the manual shift shaft comes out of the tip of a cable gear selection. Install selector cable into the bracket.
| 
