printable version
Replacing bulbs dipped beam
1. Make sure the main light switch is in the "OFF". 2. Lift the hood and determine the rear side of the headlight housing arrangement of lamps installed in the headlights and driving lights. The lamp is located at the edge belongs to the headlamp beam, and the lamp is located near the center of the car - headlight beam. 3. When replacing the right headlight bulb, start the engine and turn the steering wheel all the way to the left. Then stop the engine. If you are replacing the left headlight bulb, turn the steering wheel all the way to the right.
| Fig. 1.195. Tighten the screws on the housing Dirt
|
4. Remove the screws by turning them counterclockwise, and partially remove the mud guard (Fig. 1.195). 5. Turn the sealing cap anticlockwise and remove it. 6. Disconnect the electrical connector from the bulb by pulling it back.
8. Pull the spring clip to the side to release the lamp. 9. Carefully remove the bulb from the socket by pulling it back. 10. Replace the lamp. 11. Install all the parts, perform the above steps in reverse order.
|