REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz E-Class

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mercedes-Benz
	E-class
		Introduction
		Description of the model Mercedes E-Class
		Working conditions and tools
			Workplace
			Acquisition of spare parts
			Basic tool
			Special Tools
			Accident prevention
			Lifting the car jack
				Basic racks
				Jacking
			Technique Mechanics
			Delivery of the car repair
		Car Care
		Diesel engines
		Petrol engines
		Transmission
		Chassis
		The brake system
		Electrical
		Shop
		Body
		Applications
		Diagrams

printable version

Basic racks

Fig. 2.22. Designated installation pedestals

For safe operation when the vehicle is partially raised are support columns of different sizes. For the majority of work only two such posts. When purchasing racks note the size of the base, it is desirable that it was not too small for the transmission of pressure on the ground. Installation locations struts on the vehicle shown in Fig. 2.22.

Note that when you install the desk rested against the rubber pad exactly in the corresponding threshold in order to avoid damaging it. As an intermediate gasket can additionally use a dry board or hard rubber.

A WARNING

It is important that one of the three legs of the rack has been exposed in the direction of the body, or when the vehicle rolling rack can be displaced and tip.

A pin serving for adjusting the height of the rack should be pushed into the hole to lock and lock pin.

« previos page
Lifting the car jack

next page »
Jacking