printable version
Removal and installation of other finishing panels
Components lateral part of the passenger compartment Components lateral part of the 5-door saloon models The components of the side trim 3-door models
| - To remove the trim panels liberate them from the clamps. If necessary, remove adjacent components finishing.
- To remove the upper section of the B-pillar trim previously required to remove the upper seat belt anchor (see. Section Removal and installation of the front seat belts).
- To remove the back side panel trim, remove the seat cushion beforehand.
- To remove the border of the rear window, remove the pre-section of the rear side trim upper section of side trim luggage compartment and the upper seat belt anchor (see. Section Removal and installation of the front seat belts).
- Installation is in the reverse order. Use the new locks and make sure that the panel clung to them.
|
|
Finishing the ceiling Installation components finishing the ceiling
| - Remove the upper section of the finishing stands A and seal opening tailgate.
- Remove upper section of side trim luggage
- Remove the ceiling handle, overcome their catches to the side of the cabin.
- Remove sun visors and cabin lighting (See chap. Onboard electric equipment).
| - Remove the sun visor holder, which insert a screwdriver into the slot and turn it by 90 degrees.
|
- Release the rear panel of the holder, cut the tape and remove the trim panel ceiling.
- Installation is in the reverse order.
|
|
Finishing luggage Components finish luggage
| - To remove the trim panels liberate them from the clamps. If necessary, remove adjacent components finishing.
- To remove the bottom side of the section you want to remove the pre-back and the rear bench seat (see. Section Removal and installation of rear seat).
- Installation is in the reverse order. Use the new locks and make sure that the panel clung to them.
|
|
|