printable version
Removing and installing glass windows and side doors
The front doors The components of the installation of glass and the front window | | |
| - Remove the door trim (see. Section Removing and installing door trim panels) and completely lift the glass.
- Disconnect the front speaker and remove the seal.
| - On the 5-door models, remove the inner frame of the front door.
|
- On models with the system ?�Intelligent Key?� Remove the buzzer.
- Remove the screws bottom rear guide, slide the bottom of the rail forward and pull it out of the door.
| - Hold the glass by hand and in terms window switch, set the glass into a position where it will be available to the mounting bolts. Remove the screws of the glass.
|
- Remove the glass from the door to the outside by pulling the rear edge.
| - Disconnect and remove the bolts e / window motor. Remove the window assembly.
|
- Remove the lower front window is similar to the back of the guide.
- Remove the corner piece and the top guide.
- Installation is in the reverse order.
| - After installation, program windows. To this end, fully raise the glass, and then pressing the reset switch, then lower the glass. Release the switch. Once he returns to the starting position, lift the glass.
|
|
|
Rear doors Components installation window and rear door windows
| - Remove the door trim (see. Section Removing and installing door trim panels), disconnect the rear speaker wiring and remove the seal.
| - Remove the bolts and screws fastening directing a fixed window, pull it down, pull the top side and remove the guide.
|
- Remove the fixed glass, pulling it toward the front of the vehicle.
| - Hold the glass by hand and in terms window switch, set the glass into a position where it will be available to the mounting bolts.
|
- Remove the screws and remove the glass window of the door, pulling it over.
| - Disconnect the connector, remove the bolts assembly window and remove it.
|
- Remove the guide rolling glass.
- Installation is in the reverse order.
|
|
|