add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Golf II, Jetta (from 1983 to 1992, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks
Volkswagen Golf 2 / Jetta
Home
 
Volkswagen
Golf 2 / Jetta
General Information
Engine
The power supply system
Coupling
Transmission
Transmission
Front-wheel Drive
A steering
Suspension
Brakes
Body
Front bumper
Rear buffer
Cover the back buffer
Grille
Panel Rack
Front fender
Lokar
Decorative molding
Drains
Laths of the roof drains
Door handles
External door lock
Internal door lock
Adjusting the door lock
Door mirror
The upholstery of the door panel
Glass doors
Wind and lateral motionless glass
The inner door handle
Windows
Central door lock
Front seat
Tailgate
The mechanism of management of a heater
Electrical
 


Hit Counter by Digits


print page printable version

Front fender



Front fender

1 - body;
2 - a bolt;
3 - the screw;
4 - front wing

Withdrawal

PERFORMANCE ORDER
1. To remove the buffer (see. Subsection 11.1).
2. Loosen the bolts of the front wheel.
3. Lift the front of the car and establish on support.
4. Remove the wheel.
5. Remove Lokar (see. Subsection 11.7).
6. Remove antenna, if installed.
7. Remove the rubber buffer hood.
8. Loosen the screws trim strip 1 (see. Fig. Details Chuck) on a rented wing.
9. Remove bolts 2 hex-head screws and three Phillips.
10. Clean off with a sharp object anticorrosion coating in places of joining the wing to the floor.
11. Remove the wing, shaking him and hooking screwdriver.

Setting

PERFORMANCE ORDER
1. Clean the surface of the wing to the body connections.
2. Install a new sealing tape wing.
3. Punch a hole in the sealing tape at fixing bolts.
4. Install the wing 4.
5. Tighten all bolts and screws 3 2 fastening wing.
6. Apply anti-corrosion coating on the inside of the wing and in the joints.
7. Install the rubber buffer hood.
8. Place the antenna, if available.
9. Install Lokar (see. Subsection 11.7).
10. Tighten the screws fastening of a decorative overlay 1 (see. Fig. Details Chuck).
11. profit wheel bolts.
12. Lower the vehicle to the ground.
13. Tighten wheel torque of 110 Nm.
14. To establish a buffer (see. Subsection 11.1).




« previos page
Panel Rack
next page »
Lokar

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.