printable version
Door mirror
Models of release till 07.1987 G. (mirrors with manual adjustment)
Door mirrors with manual adjustment of release till 07.1987 1 - the handle; 2 - a protective casing; 3 - a nut; 4 - an arm; 5 - adjustment mechanism; | 6 - a lining; 7 - a decorative casing; 8 - mirror; 9 - the screw; 10 - a bolt |
Withdrawal PERFORMANCE ORDER | 1. Remove the handle 1. | 2. Remove the protective cover 2. | 3. Remove the door trim panel (see. Subpart 11.16). | 4. Loosen the nut 3. | 5. Remove the decorative casing 7. | 6. Unscrew the screws 9. | 7. Remove the mirror 8 with the adjustment mechanism 5. |
|
Install the outside rearview mirror is carried out in reverse order.
MODELS OF RELEASE AFTER 07.1987 G. (mirrors with manual adjustment)
From 08.1987 there were changes in the design of the mirror attachment to the body and attaching the reflective element in the body. Door mirrors with manual adjustment of release with 07.1987 g 1 - reflective element; 2 - dowel pin; 3 - the mechanism; 4 - the case; 5 - inlay; 6 - a lining; 7 - the screw; 8 - pin; | 9 - the door frame; 10 - the handle; 11 - piston; 12 - a protective casing; 13 - a nut; 14 - an arm; 15 - adjusting mechanism |
Refitting PERFORMANCE ORDER | | 1. When removing the reflective element to stick pieces of adhesive tape on the body 4 1 mirror to protect the body. Pry off the reflective element 3 2 wooden spatula from the bottom and then the top and pull it out of the housing 4. | 2. Install reflective element 2 pins (see. Fig. Door mirrors with manual adjustment of release with 07.1987 g) in seating and gently press on the center of the reflecting element 1 so that it snaps into place. | 3. The remaining steps for removing and installing a mirror similar to the early release (see. |
|
Models of release till 07.1987 G. (mirrors with electric adjustment) Electric adjustment mechanism | 1 - the screw;
2 - electric motor;
3 - the case;
4 - Wire |
Withdrawal PERFORMANCE ORDER | | 1. Turn the retainer 2 with the screwdriver 1 in the direction indicated by the arrow. Remove the reflective element 3 of the body 4. | 2. Remove the screws 1 (see. Fig. The mechanism of the electric adjustment). | 3. Remove the motor 2. | 4. Disconnect the wires 4. | 5. Remove the switch with the door trim panel. | 6. To disconnect the connector. | 7. Remove the door trim panel (see. Subpart 11.16). | 8. Remove the protective film. | 9. Loosen the clamp wires. | 10. Disconnect the wires contacts | 11. Loosen the screws that secure the mirror housing to the door and remove it. |
|
Setting PERFORMANCE ORDER | 1. Install the outside rearview mirror is carried out in order. When installing wires to connect to the motor in accordance with the color. | 2. Stick the protective film from the double-sided adhesive tape. | | 3. Turn the stop catch 2 in the direction indicated by the arrow. Set the reflecting element 3 in the housing 4. Turn the retainer 2 with the screwdriver 1 in the direction opposite to the direction of the arrow. |
|
|