REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Passat B6 (from the year 2004)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Volkswagen
	Passat B6
		Operation and maintenance of car
		Engine
		Transmission
		Chassis
		Steering Gear
		Brakes
		Onboard electric
		Body
			Design Features
				Removal and installation of facing of the front bumper
				Removing and installing rear bumper fascia
				Removing and installing front wheel arch liner
				Removing and installing rear wheel arch liner
				Removing and installing mirror glass
				Removing and installing body side mirror
				Removal and installation of overlays
				Removing and installing the side direction indicator
				Removal and installation of mirrors
				Removing and installing radiator grille
				Removal and installation of the emblem
				Removal and installation of the license plate
				Removal and installation of roof rails
				Removing the attachment bracket
				Installing the attachment bracket
				Installation of the new attachment bracket
				Removal and installation of the waterproof lining
				Adjustable hood
				Adjust the bonnet
				Adjusting tailgate
				Adjust the bracket lock
				Adjusting the door
				Removing windscreen
		diagrams

printable version

Removing and installing the side direction indicator

NOTE

Description removal and installation is only for the left side direction indicator. Removal and installation of the right side direction indicator is similar.

The indicator lamps in the door mirrors are installed than traditional incandescent bulbs, and long-lasting LEDs.

Therefore there is no need to replace the lamp. In the event of a fault must be replaced entirely Indicator.

Withdrawal

Remove the mirror glass.

Remove the mirror.

Remove the cover.

4 Remove the screws and remove the mounting plate 1 in the downward direction.

Fig. 8.11. Removing Indicator

Disconnect the connector 5 from 3 Indicator (Fig. 8.11).

2 Remove the screws and remove the turn signal 3 with fastening element 1 (Fig. 8.11).

Setting

Installation is carried out in reverse order.

After installation, check operation.

« previos page
Removal and installation of overlays

next page »
Removal and installation of mirrors