 printable version
Suspension
Front axle 1. Upper knuckle
2. Right torsion
3. Shock
4. The right half
5. The bracket hinged units | 6. Lower the knuckle
7. The left transverse steering rod
8. Upper hinge axis
9. Wheel bearing |
Front suspension 1. Nuts, 160 Nm
2. Shock
3. Remote handset
4. Lower the support ring
5. Screw 100 Nm
6. strut
7. The top support ring
8. Washer
9. Nut, 25 Nm
10. A nut 100 Nm
11. Buffer
12. A nut 110 Nm
13. Lower the knuckle
14. Vent flap
15. A nut 160 Nm
16. Front bearing sleeve
17. Allen screw M14x1,5x82
18. The eccentric screw M12 or M14
19. The rear bearing sleeve
20. The eccentric washer
21. Nut M12 x 1.5 or M14h1,5
Note: Depending on the thread, a different tightening torque: M12 - 75 Nm 90 ?° dozatyazhki, M14 -160 Nm
22. Lower the knuckle
23. Connecting rod
24. Allen screw
25. A nut 110 Nm
26. The eccentric washer
27. The eccentric bushing
| 28. The upper axial joint
29. The upper knuckle
30. Retaining Ring
31. A nut 100 Nm
32. Front bearing sleeve
33. Allen screw M12h1,5x80
34. The rear bearing sleeve
35. A nut 100 Nm
36. Allen vintM14h1,5x42
37. Allen screw M14h1,5x30
38. A nut 160 Nm
39. Torsion
40. Lever torsion
41. Nut torsion
42. adjusting screw torsion
43. Hex screw 160 Nm M14h1,5x40
44. Hex screw 100 Nm M12h1,5h32
45. Screw 55 Nm
46. Clamp
47. Support sleeve stabilizer
48. Stabilizer
49. Rubber Bearing
50. Screw 55 Nm
51. The rubber mounts
52. The welded nut
53. With the bracket mounted units 8/92 (FG ?„–70RN004343) |
A warning  With the bracket mounted units 8/92 (FG ?„–70RN004343) installed bracket mounted units with a modified design of the rear transmission mount. This bracket mounted units can not be installed on older machines that were released prior to that date.
With 11/91 (FG ?„–70M083342) changed eccentric adjustment screw Caster with M12 to M14. In this regard, as modified elongated hole for adjusting the pin and bushing rear rubber mounts from 12 mm to 14 mm. This applies to items 18, 19, 20, 21 and 53.
|
