 printable version
Replacing the working cylinder of the rear wheel brake
If during the operation there were streaks of brake fluid in the brake drum and the inner side of the wheel, or stuck piston in the cylinder, replace the slave cylinder. You will need: the keys "9", "10" special key "10" for nuts, pipes, key to the wheel bolts. 1. Turn on the set and I transfer Chock the front wheels. 2. Remove a corresponding back wheel. 3. Remove any dirt from the brake pipe attaching bolts and the working cylinder on the back of a brake board. 5. Lift the parking brake lever - upper ends of the pad will depart from stops pistons. | | 6. Remove the protective cap and turn the valve to remove the air. | 7. Remove the nut of a brake tube to the working cylinder and plug the hole of the tube, such as a cap vent valve. |
HELPFUL ADVICE After prolonged use of a brake tube nut "fused" with a pipe in one piece, so when you try to unscrew the nut of the tube is twisted and broken. In this case, only a few stronte tube nut, then loosen the bolt cylinder and disconnect the tube, svinchivaya cylinder with its nut. After disconnecting the cylinder from the mobility of the released tube nut can be restored by moistening with brake fluid and turning nut wrench alternately in both directions. |
| | 8. Remove the bolt of the working cylinder, holding the cylinder with the other hand ... | 9. ... and remove the working cylinder. |
10. If the valve air release new cylinder is no protective cap, remove it from the old valve. 11. Install the slave cylinder in the reverse order of removal. 15. Several times sharply depress the brake pedal to bring the pads to the brake drum.
| 
