 printable version
Seat belts
Refitting |  | - Remove the lower mounting bolt front seat belt blade and a flathead screwdriver, lift up and remove the B-pillar trim. Torque: 40-55 N ??? m.
|
 | - Remove the bolt securing the front of the upper belt. Torque: 40-55 N ??? m.
|
 | - If the vehicle equipment tightener, disconnect the wire from the negative terminal of the battery, disconnect the connector from the gas generator and remove the belt tensioner.
|
- Installation is performed in reverse order of removal.
|
|
 | - Module pretensioner is triggered only once.
- Do not disassemble or repair the unit pretensioner.
- Do not drop the module pretensioner and prevent it from contact with water, grease, etc. If there are any dents, cracks, deformation or corrosion, replace the module.
- Connect the wire to the negative terminal of the battery only after proper installation module pretensioner.
- Removing the belt pretensioner:
??? Make sure the ignition is turned off.
??? Disconnect the negative terminal of the battery and make sure it does not touch the body.
??? Wait 1 minute.
??? Disconnect the electrical connector from the gas generator.
??? Remove the bolt and remove the module pretensioner.
|
|
