add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Jeep Grand Cherokee (from 1993 to 1999, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks
Jeep Grand Cherokee
Home
 
Jeep
Grand Cherokee
Introduction
eleven About this Guide
Cars of mark Jeep Grand Cherokee - Abstract
The vehicle identification number
Purchase Parts
Equipment service, the tool and the workplace equipment
Jacking and towing
Poddomkrachivanie
Towing
Starting the engine from the auxiliary power supply
Automotive chemicals, oils and greases
Troubleshooting
Adjustment and routine maintenance
The straight six-cylinder engine
The V8 engine
Procedure of the general and engine major repairs
Systems of cooling, heating and air conditioning
The power supply system and exhaust
The system of electric motor
Systems of decrease in toxicity of the fulfilled gases and engine management
Manual box of a gear change
Automatic Transmission
Transfer Case
Clutch and transmission line
Brakes
Suspension and steering
Body
The system of on-board electrical equipment
Controls and operation receptions
 


Hit Counter by Digits


print page printable version

Poddomkrachivanie



Poddomkrachivanie

The jack supplied with the kit to the car is intended solely for lifting it in the process of changing the wheels or to be mounted on a frame intravascular backup. IN NO EVENT does not perform any work under the vehicle and run the engine if the vehicle is locked in the raised position only through this jack.

The vehicle must be parked on level ground, the wheels are locked, and the transmission is in reverse gear position (Manual transmission) or <P> (Parking) (AT). In the case of forced stop on the track, coupled with the need for repairs do not forget to turn on the alarm system. If the wheel is to be replaced, after loosening its fastening screws a half-turn, and do not remove them until the wheel is off the ground.

Get a jack under the car in one of the points in the illustration. The slow flowing movements cock jack so that the wheel is off the ground. Remove the wheel and install in its place the spare tire. Loosely wheel nuts by tightening them by hand. Lower the car on the earth and tighten wheel nuts with torque wrench in diagonal order with demanded effort. Remember that some of the spare wheel designs are not designed for permanent use, but only for the delivery of the car to the place of repair - during a trip hazard, do not exceed the recommended maximum permitted speed and the path length (see. The instructions for use specific spare wheel).

The front and rear jacking points




« previos page
Jacking and towing
next page »
Towing

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.