add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Jeep Grand Cherokee (from 1993 to 1999, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks
Jeep Grand Cherokee
Home
 
Jeep
Grand Cherokee
Introduction
Adjustment and routine maintenance
The straight six-cylinder engine
The V8 engine
Procedure of the general and engine major repairs
Systems of cooling, heating and air conditioning
The power supply system and exhaust
The system of electric motor
Systems of decrease in toxicity of the fulfilled gases and engine management
Manual box of a gear change
Automatic Transmission
Transfer Case
Clutch and transmission line
Brakes
Suspension and steering
general information
Removing and installing front stabilizer lateral stability and bushings
Removal and installation of the front shock absorbers
Removal and installation of the transverse jet bar front suspension
Removal and installation of the front suspension arms
Removing and installing coil spring front suspension
Removing and installing steering knuckle
Replacement ball joints
Removing and installing rear stabilizer rod transverse stability
Removing and installing the rear shock absorbers
Removal and installation of the transverse jet bar rear suspension
Removal and installation of levers of a back suspension
Removing and installing coil spring rear suspension
Removing and installing steering wheel
Condition check, removal and installation of steering gear
Removal and installation of the steering mechanism
Removal and installation of the pump system hydrostrengthening steering
Bleeding the steering system hydrostrengthening
Wheels and tires - general information
Corners of installation of forward wheels - the general information
Body
The system of on-board electrical equipment
Controls and operation receptions
 


Hit Counter by Digits


print page printable version

Suspension and steering



Specifications

The corners of the front axle

The convergence of the front wheels

16 +1.5 mm (0 ? 14 '

12 '

)
-16 -14'

Slay

-0 ? 15 ' 45 '
-thirty'

The longitudinal tilt axis of the front wheels

7 ? ? 30 '

The maximum angle of rotation of the outer wheel to turn

33 ?

Efforts of a tightening of carving connections, N ??? m

Front suspension

Shock absorbers
  • The upper nut
19.0
  • Lower nut
19.0
Stabilizer of transverse stability
  • Nut stabilizer bar to a connector (front)
37
  • Bolts of collars of plugs of the stabilizer
54
Bolts and nuts suspension arms
  • The top lever (both ends)
75
  • The lower arm (round trip)
176
Transverse torque rods
  • Nut stud ball joint to an arm frame
81
  • Bolt / nut on the bracket axle housing
75
Nuts of fastening of the steering knuckle to the Ball joint fork axle beam (with a forked end)
102

Rear suspension

Shock absorbers
  • The upper nut
71
  • Lower nut
60
Stabilizer of transverse stability
  • Nut stabilizer bar to a connector (front)
37
  • Bolts of collars of plugs of the stabilizer
54
Bolts and nuts suspension arms
  • The top lever (both ends)
75
  • The lower arm (round trip)
176
Transverse torque rods
  • Bolt / Nut jet bar to the frame rail bracket
100
  • Bolt / Nut jet bar to an arm bridge
100

Steering

Nut fixing the steering wheel hub on the shaft of the column
34
Nuts of fastening of the steering mechanism
88
Nut bipod to the steering mechanism
251
Nut steering pitman arm to the average steering draft
75
Nut middle steering rod to the steering knuckle
47
Nut connecting rod to the middle
75
Nut connecting rod to the steering knuckle
49
Nuts of collars of fastening of the regulator (s) of the steering rod (rod)
49
Nut steering damper actuator to the average steering draft
47
Bolt steering linkage damper bracket to the bridge
75
Wheel nuts




« previos page
Replacement of boots of a lay brake (disc brakes rear wheels)
next page »
general information

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.