add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Magentis / Optima (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks
Kia Magentis
Home
 
Kia
Magentis
Engines
Lubrication System
Cooling system
The control and toxicity
Fuel system
Ignition system
Coupling
Transmission
Power shafts, axles
Suspension
Steering
Brakes
Body
The air conditioning system
Technical data
Service air conditioning systems
Remarks at replacement of elements of the air conditioning system
Merging an air-conditioning system
A compound member having a guide pin
Setting gauges for pressure measurement
The evacuation of air from the air conditioning system
Connecting the exhaust valve to the cylinder with the refrigerant
Charge air-conditioning system
Oil for air conditioning compressor
Check hoses and tubes
The noise of the compressor
Check and adjust the tension of V-ribbed belts
Verification performance
Triple Sensor Pressure
Check condenser fan relay
Check the air conditioner switch
Check the mode switch
Check switch fresh / recirculated air
Air conditioning compressor
Bushing clutch pulley and the air conditioning compressor
The excitation coil clutch
The fan and the condenser
Check the fan motor
Troubleshooting
Check of the relay and the air conditioning condenser fan
Check of the relay of the fan heater
Electrical equipment
Electrical diagrams
 


Hit Counter by Digits


print page printable version

Charge air-conditioning system



PERFORMANCE ORDER

Charging the air conditioning system should be carried out in the gaseous state refrigerant through the low pressure side. When the cooling container is placed on the right side, the refrigerant will enter the system as steam.

1. Connect the exhaust valve to the cylinder with refrigerant.

2. Open the low-pressure valve and adjust it so that the low pressure gauge indicates the pressure of not more than 412 kPa.

3. Place a container with a refrigerant to water heated to a temperature of 40 ?� C, to maintain the vapor pressure in the container is slightly higher than the vapor pressure in the system.

4. Start the engine in a mode of fast idling and the air conditioner.

Ensure that the container support rack to prevent the ingress of liquid refrigerant through the side of a low pressure, as this may damage the compressor.

5. Charge the system precisely set amount of refrigerant and close the discharge valve.

The amount of refrigerant: 670 ?� 25 g

When the charging rate decreases, the refrigerant container is put in water heated to a temperature of 40 ?� C (104 ?� F).

In all circumstances, the coolant can not be heated in water above a temperature of 52 ?� C (126 ?� F).

To heat the coolant should not be used a blowtorch.





« previos page
Connecting the exhaust valve to the cylinder with the refrigerant
next page »
Oil for air conditioning compressor

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.