add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 6 (2002 release)

general info. full specifications. diagnostics. hints. tips. tricks
Mazda 6
Home
 
Mazda
6
Operation and maintenance of car
Engine
General description new engines models L8, LF, L3
The mechanical part of engines
Engine Model L8 or LF
Checking the contents of the CO / CH in the exhaust gas
Measurement of engine compression
Verify accessory drive belt
General information and safety when removing the power unit
Removal of sealant
Removal and installation of the power unit
Check actuator variable valve timing (L3)
Removal and installation of the actuator variable valve timing (L3)
Timing chain drive
Removal and installation of the oil control valve (OCV) (L3)
Checking the oil control valve (OCV) (L3)
By operation of the spool valve (OCV) (L3)
General repair operations on the power unit
Check the cylinder head
Assembling the cylinder (the beginning)
Assembling the cylinder (the end)
Assembling the cylinder head
Assembling the valve timing
Appendix 1
Annex 2
Appendix 3
Transmission
Chassis
Steering Gear
Brakes
Onboard electric
Body
 


Hit Counter by Digits


print page printable version

Checking the oil control valve (OCV) (L3)



Disconnect the negative battery cable.
Disconnect the connector of the oil control valve.

Installation of a special device
Fig. 2.103. Installation of a special device


Measure the resistance between terminals A and B using an ohmmeter (Fig. 2.103).
If the result is different from the specified, replace the control oil valve.
The standard description of the indications of an ohmmeter - 6,9-7,9 Ohm.

Conclusions connector control of the oil valve (OCV)
Fig. 2.117. Conclusions connector control of the oil valve (OCV)





« previos page
Removal and installation of the oil control valve (OCV) (L3)
next page »
By operation of the spool valve (OCV) (L3)

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.