 printable version
Removal and installation of the power unit
Remove the battery. Remove the tray battery. Remove the radiator. Drain Remove the power steering oil pump with oil filter, without disconnecting the hose and place it so that it does not interfere. Remove the compressor of the air conditioning system without disconnecting the tubes. Place the compressor air conditioning system so that it does not interfere. To fix the compressor using wire or rope. Remove the shaft combined with the intermediate shaft drive. Remove the air filter, air intake duct, wire accelerator bracket and vacuum hose. Remove the filter and an automatic transmission selector lever cable. (models with automatic transmission). Remove the vacuum hose and heater hose. Remove the clutch slave cylinder and control cable (models with manual transmission). Remove the plastic fuel hose. Disconnect the wiring harness in the engine compartment. Remove the front pipe.
| Fig. 2.89. The components of the power unit mounting on the car: 1 - engine mount ?��1; 2 - motor mount ?��1; 3 - motor mount and motor support ?��4 ?��4; 4 - bus connection of the engine to "weight" of the body; 5 - an arm of fastening of the engine ?��3; 6 - engine, gearbox in unit with the main transfer
|
| 
