add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 6 (2002 release)

general info. full specifications. diagnostics. hints. tips. tricks
Mazda 6
Home
 
Mazda
6
Operation and maintenance of car
eleven Description of vehicle
The dimensions and general appearance of the car
Specifications
Vehicle identification
Engine compartment
Capacities units and systems, recommended operational materials
Keys, locks of doors, sunroof, anti-theft system
Controls and instrument cluster
Device combination
Speedometer
Odometer
Modes switch odometer
Tachometer
Coolant temperature
The fuel gauge in the tank
Instrument lighting
Signalling devices and indicators, audible alarms
Display light signaling unbelted
Audible alarm
Hazard warning lights
The central stalk switch outdoor lighting
Light sensor
Xenon headlights
Far-switching modes dipped headlights
Control lever indicator lamps
Light switch the front fog lamps
Light switch the rear fog lamp
Windscreen wipers
Wiper adjustable pause in the discontinuous mode,
Windscreen
Rear window cleaner
Rear window washer (cars with hatchback)
Rear Defrost
Cigarette lighter and ashtray
Front and rear cup holders
Storage compartment in the control panel
Glove compartments and small luggage
Storage compartment in the center console
Lateral compartment
Niche luggage compartment (cars with a body "versatile")
Sunshields
Courtesy light
Map lamp
Courtesy light thresholds
Power windows
Opening and closing the electric windows on the outside of the car
Exterior mirrors
Adjusting rear-view mirrors
Electric mirror
Folding mirrors manually
Interior rearview mirror
Reducing glare of headlights
Information display
Electronic immobilizer (anti-theft system)
Heater, air conditioning and ventilation system of the car interior
Lever of lay brake system
Seats
Restraint System
Car use to destination
Troubleshooting arisen in a way or before driving
Engine
Transmission
Chassis
Steering Gear
Brakes
Onboard electric
Body
 


Hit Counter by Digits


print page printable version

Display light signaling unbelted



The driver's seat.
If the driver's seat belt is not fastened and vehicle speed exceeds 20 km / h, the indicator light will blink and the audible alarm. If you turn on the buzzer and the seat belt is unfastened, the buzzer will continue to operate even if the vehicle speed is below 20 km / h. Buzzer will turn off as soon as the seat belt is fastened or after a set time.

The front passenger seat.

Display light signaling unbelted passenger seat
Fig. 1.55. Display light signaling unbelted passenger seat


If the seat belt in the front passenger seat is not fastened and the ignition switch is in the ?�ON?� (ignition switched on), the driver and the passenger will receive a warning about using light and sound sensors. The light switch turns on the rear-view mirror (Fig. 1.55).
If the front passenger seat belt is not fastened and vehicle speed exceeds 20 km / h, the indicator light will blink and the audible alarm. If you turn on the buzzer and the seat belt is not fastened, the buzzer will continue to operate even if the vehicle speed is below 20 km / h. Buzzer will turn off as soon as the seat belt is fastened or after a set time.
To ensure the normal operation of the load sensor built into the cushion of the front passenger seat, the passenger should not enclose and sit on a booster cushion. Otherwise, because of the influence of additional cushion the load cell can not function properly. In the presence of the front passenger seat of luggage or pets indicator not wearing a seat belt can work and give the wrong signal. When placed on the front passenger seat of luggage or pets functioning alarm will depend on their weight.

Backseat.

Display light signaling unbelted rear seat
Fig. 1.56. Display light signaling unbelted rear seat


If the seat belts in the back seat is not fastened and the ignition switch is in the ?�ON?� (ignition switched on), the driver and passengers will receive a warning about using light and sound sensors. The light switch turns on the rear-view mirror (Fig. 1.56).
The switch can be red or green. If the seat belt is not fastened, the red indicator lights. If the seat belt is buckled, indicator lights green. Light detectors are working, even if there are no rear-seat passengers. The buzzer is activated only if you detach the pre-buckled belt.

NOTE
If the seat belts in the back seat will not be fastened within a specified time after the engine starts, all the indicator lights turn off.

Warning open door.
Warning lights when one of the doors (including the rear tailgate) is open or not completely closed.

Warning minimum level of liquid in the washer tank.
Warning warns the driver that the reservoir windshield washer and headlamp remains minimal amount of liquid. If the light is lit, top up the washer fluid.

Automatic transmission warning light.
Warning light comes on for a few seconds after turning the ignition switch to ?�ON?� (ignition on). Alarm is activated when a fault is detected automatic transmission.
The illumination indicates a failure of the electrical system of an automatic transmission. In this case, the vehicle continuing the movement may damage the automatic transmission.

Warning light (red) / indicator of access to the car and start the engine without a key (green) - vehicles with worn cards ?�Advanced Key?�.
This switch / indicator may be red or green.

Warning light ?�KEY?� (red).
When you turn the ignition switch to ?�ON?� (ignition switched on) indicator lights up briefly and goes out.
If the system of access to the car and start the engine without a key is faulty, the alarm goes off, and will continue to burn.

ATTENTION
It does not operate the vehicle if there is a warning lamp ?�KEY?�.
If the dashboard turned on and stays red switch ?�KEY?�, it should immediately switch to an auxiliary key. Stop the car in a safe place, with all necessary precautions. In order to continue driving the vehicle, use the auxiliary key.

The following are conditions under which the flashing red switch ?�KEY?�, warning the driver that it is impossible to turn the ignition switch from position ?�LOCK?� (locking) to the "ACC" (auxiliary power consumers), even if the grip switch is pressed and drowned:
- The battery of the wearable card ?�Advanced Key?�;
- Worn map ?�Advanced Key?� is outside the range of the system;
- Worn map ?�Advanced Key?� is located in an area where the system can not detect a signal;
- In the area of the system is the key of another brand that is worn similar to a map ?�Advanced Key?�.
Below are the conditions (in the case where the ignition switch has not been returned to position ?�LOCK?� (locking)), under which the red switch ?�KEY?� is constantly flashing, warning the driver that the worn card was removed from the car. Alarm stops flashing when the card will be worn again in the car.
The ignition switch is not returned to position ?�LOCK?� (locking), opened the driver's door and the worn card is removed from the vehicle. The ignition switch is not returned to position ?�LOCK?� (locking), and all the doors are closed after removing the worn card from the car.

NOTE
Along with the flashing red signaling ?�KEY?� an audible warning signal.

Indicator ?�KEY?� (green).
Indicator ?�KEY?� green lights on the instrument panel when the driver depresses the handle and utaplivaet ignition switch, which is set to ?�LOCK?� (locking). The indicator confirms the presence of a car registered worn cards ?�Advanced Key?� and the opportunity to turn the knob on the ignition switch to the "ACC" (auxiliary power consumers).
If the battery is worn cards ?�Advanced Key?� is low, the indicator ?�KEY?� will blink for 30 seconds after the ignition switch is turned from the position ?�ON?� (ignition on) to the "ACC" (auxiliary power consumers) or ?�LOCK?� (locking). Replace the battery before you lose the card is worn operation.

Alarm anti-theft system (electronic immobilizer).
This indicator flashes at a frequency of 2 seconds after the ignition switch is turned from the position ?�ON?� (ignition on) to the "ACC" (auxiliary power consumers) and turn anti-theft system (immobilizer).
Alarm stops flashing when turning the ignition switch to ?�ON?� (ignition switched on) using the registered ignition key. This anti-theft system (immobilizer) is switched off, and the switch is turned on and lights up about 3 seconds, then goes out.
If the engine fails to start using the registered ignition key and the immobilizer indicator stays on continuously or flashing, it may be a problem with the anti-theft system.

LED indicator main beam.
The indicator lights in the following cases:
the headlight of headlights;
direction indicators control lever is pressed to turn on the alarm-beam assistant.

LED fog lights turn on.
The indicator lights when the front fog lamps.

Power indicator rear fog light.
The indicator lights up when the rear fog light.

On indicator range (automatic transmission).
The indicator shows the position of the automatic transmission range switch (indicator works with the ignition).

The gear indicator.
If the switch lever is in the ranges "D" (move), or the "M" (manual shift mode), the display shows the selected gear in the automatic transmission.

Power indicator glow plugs (diesel cars).
The indicator can light up when you turn the ignition switch to ?�ON?� (ignition on). The light goes off after the complete warming glow.

Operation indicator / warning lamp and traction protivozanosnoy systems.
The indicator lights for a few seconds after turning the ignition switch to ?�ON?� (ignition on). The indicator flashes when activated traction control (PBS) or protivozanosnoy system (CCD). If the light stays on, it may indicate a violation of the normal functioning of BSS systems and CCD. This system may not work properly.

Indicator off protivozanosnoy system.
The indicator lights for a few seconds after turning the ignition switch to ?�ON?� (ignition on). The indicator also lights up when you press the switch ?�DSC OFF?� and warns the driver that the ASR system and BSS system protivozanosnaya CCD disabled.
If the light stays on when non-disabled BSS systems and CCD, it may be due to malfunction protivozanosnoy system.
Power indicator cruise control (yellow) / Indicator specify stabilized speed (green).
This indicator may be yellow or green.
The indicator lights up in amber when you press the main switch ?�ON / OFF?� cruise control. This LED indicates that the cruise control system is enabled.
The indicator lights up green when the set speed to be stabilized.

Power indicator lighting devices.
The indicator lights up when the exterior lighting and lighting of the dashboard.

Turnout on lamp indicator / hazard warning lights.
When you turn on the direction indicators flashing corresponding (left or right) indicator.
When you turn on the hazard warning lights flash simultaneously both LEDs.

NOTE
If the light stays on (not flashing) or flashes with increased frequency, the possible cause of burnout is one of the indicator lamps.




« previos page
Signalling devices and indicators, audible alarms
next page »
Audible alarm

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.