add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 626 (from 1991 to 1998, the year of issue)
general info. full specifications. diagnostics. hints. tips. tricks
 Mazda 626
Home
 
Mazda
626
Instructions
Maintenance
Engines
Heating and ventilation
Fuel system
Carburetor Nikki 30/34
The power supply system (engines 1,6 and 1,8)
Introduction
Specifications
Release of pressure from the power supply system
The fuel pump / pressure feed system
Fuel tubes and connections
Removal and installation of the fuel pump
Fuel Level Sensor
Fuel tank
Air filter
An accelerator rope
Electronic fuel injection
The power supply system (engines 2,0 and 2,5)
An exhaust system
Transmissions
Coupling and semiaxes
The brake system
Chassis
Body
Electrical
Wiring
Tips and Tricks
 


Hit Counter by Digits


print page printable version

Fuel Level Sensor



Resistance at the float lever is down (the fuel tank is empty)

Resistance at the lowered float arm should be around 110 ohms.

Resistance at the raised arm of the float (the fuel tank is full)

Resistance at the raised arm of the float should be about 2-4 Ohm.

Check

PERFORMANCE ORDER
1. Cnimite fuel pump and check that the resistance of the sensor changes smoothly when the float is lowered from 110 ohms to about 2-4 ohms.
2. Replace the sensor if necessary.

Replacement

PERFORMANCE ORDER
1. Disconnect a connection socket.
2. Remove the retaining nut and remove the gauge.
3. Installation is spent upside-down removals.




« previos page
Removal and installation of the fuel pump		 next page »
Fuel tank

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.