 printable version
Removing and installing electric motors drive the wiper
Details of installation of electric drive windshield wiper
| - Details of the installation of the electric motor drive the windshield wiper shown in the illustration, which includes all the links in the text.
- Remove the wiper drive assembly (see chap. Body).
- Loosen the axle nut (1) and remove the screws (3) securing the assembly to the motor (M6 / 1) drive rod (2).
- Disconnect the wiring connector (H88 / 2) and remove the assembly of the drive motor (M6 / 1).
- Installation is in the reverse order - track correctness of installation of the parking position of the actuator, with HERZ-TS axle nut (1) on the motor shaft, make sure that the drive lever was lowered vertically downwards.
|
|
Windscreen wipers Details of installation of electric drive rear wiper
| - Details of installation of electric drive rear wiper shown in the illustration, which includes all the links in the text.
- Bring the drive to a parking position.
- Remove the interior tailgate trim (see chap. Body).
- Remove the rear window wiper arm (see chap. Body).
- Remove the brake upper level (see. Section Removal and installation of the central stoplight upper level).
- Disconnect the electrical connector (3).
- Disconnect the connector from the choke (1) tube feeding washer fluid.
- Remove the screws (2) securing the drive assembly to the tailgate.
- Remove the drive motor (M6 / 4).
- Installation is in the reverse order - if necessary, replace grommet doorframe.
|
|
|
