REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz C-Class (W203, 2000 issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mercedes-Benz
	W203
		Introduction
		Instruction Manual
		Routine maintenance
		Engine
		Cooling and heating
		The power supply system and release
			The power supply petrol and diesel engines
			The fuel injection system gasoline engine
				Security measures at work with injection petrol engine
				The functioning of the control system and injection petrol engine
				Total system verification injection petrol engine
				Removal and installation of the air mass meter
				Check injectors
				Removal and installation of a fuel distributive highway and injectors
				Check and adjust idle speed / ignition timing / CO
			The fuel injection system of the diesel engine. Turbocharger
			Exhaust systems and reduce emissions. Turbocharger
		Electric motor
		Manual gearbox
		Automatic Transmission
		Coupling and power shafts
		Brakes
		Suspension and steering
		Body
		Onboard electric

printable version

Removal and installation of the air mass meter

Air mass meter and intake manifold


1 - Air intake 2 - The coupling member 3 - throttle actuator 4 - damper 5 - flange inlet pipe 6 - Gasket	7 - meter air mass 8 - air hose 9 - air duct 10 - Seal 11 - the Inlet pipeline

6-cylinder petrol engine 112

Withdrawal

PERFORMANCE ORDER

1. Remove the air filter housing with the cylinder head cover straight up.
2. Disconnect the connector of the air mass meter.
3. Remove the ventilation hose from the measuring instrument and disconnect from the holder.
4. Release the upper clamp meter air mass.
5. Pull the top latch hook on the air intake pipe. Thus, the press mass meter back so that the lock could no longer be fixed.
6. Press the air intake pipe clamp screwdriver down.
7. Remove the air mass meter to the inlet pipeline.

Setting

PERFORMANCE ORDER

1. Installation is performed in reverse order of removal.
2. Visually inspect the O-rings meter weight for damage and replace if necessary.
3. Before installing the air filter housing, lubricate with a thin layer of grease, for example, ?�NaphtolenH?� rubber elements on the cylinder head cover and the O-ring gauge.

« previos page
Total system verification injection petrol engine

next page »
Check injectors