 printable version
Drive motors, sensors
Removing and installing electric motors drive the wiper The front wipers Details of installation of electric drive windshield wiper  | | |
| - Remove the key from the ignition and disconnect the wire from the battery.
- Remove the supports and lower down solenoid valves locking differentials (Y68, Y68 / 1 and Y68 / 2), - try not to damage the vacuum lines.
 | Before disconnecting the wiring and vacuum lines do not forget to put the appropriate marking ensures the correct connection of the assembly. |
- Remove the mounting bracket (1) a reservoir (2) and, without turning, pull it down, - try not to spill brake fluid.
- Disconnect electroconducting from the gauge-switch (S62) cowl anti-theft system (ATA).
- Remove the screws (arrows) fastening clamp vent lines on the mounting bracket. Get vents under refrigeration (4) and down, take them aside. Remove the mounting bracket (1).
- Remove the cover (3) electric motor (M6 / 1) drive the wiper.
- Disconnect the wiring, remove the fasteners (arrows) and remove the electric motor (M6 / 1) with poles (arrows).
- By submitting an electric motor (M6 / 1) forward, through a window in the bulkhead, pry and separate from the crank (6) actuating rod (5), - try not to bend the rod.
- Finally, remove the electric motor (M6 / 1).
- Installation is in the reverse order.
- Finally, make the DTC reading and clearing of system memory on-board self-diagnostic scanner using STAR DIAGNOSIS (6511 1801 00) (see chap. Systems of an electric motor) and perform basic programming.
|
|
Rear Wiper Details of installation of electric drive rear wiper
| - Remove the rear wiper (see chap. Body).
- Remove the cover (1).
- Releasing clamps and without tilting, remove the central section of the top panel of the tailgate trim.
- Disconnect the connector (M6 / 4x1) electrical drive motor (M6 / 4).
- Remove the mounting bolts (3) and remove the electric motor (M6 / 4).
- Installation is in the reverse order.
|
|
|
