REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz G-Class (W463, 1999 issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mercedes-Benz
	G-class
		Introduction
		Controls and operation receptions
		Current care and maintenance
		Engine
		System of cooling, heating, ventilation and air conditioning
		The power supply system and exhaust
		Systems of an electric motor
			Ignition and engine control
				The basic data and security measures
				Checks control ignition and injection
				Troubleshooting - general information and preliminary checks
				Check and adjust the ignition timing
				Spark plug
				Removing and installing ignition coils, - petrol models
				Removal and installation of the crankshaft position sensor (CKP)
				Removing and installing the camshaft Hall sensor
				Removing and installing knock sensors (KS), - Petrol Engines
			System of preheat of the diesel engine
			Diagnostics of systems of electronic control and diagnostic equipment
			The charging system and run
		Automatic Transmission
		Transmission Line
		Brakes and auxiliary systems
		Suspension and steering
		Body
		Onboard electric
		Wiring

printable version

Removal and installation of the crankshaft position sensor (CKP)

Petrol models

Details of the sensor CKP (L5) gasoline engines

PERFORMANCE ORDER
After replacing the CKP sensor is necessary to make reinitialization control module using a special diagnostic equipment - wise to entrust the implementation of this procedure service specialist.

Diesel models (M612)

Details of installation of the CKP sensor engine M612

PERFORMANCE ORDER
Remove the trim panel of the cylinder head cover.
Disconnect the connector (1).
Remove the retaining bolt (2) and remove the gauge CKP (L5).
Installation is in the reverse order.

« previos page
Removing and installing ignition coils, - petrol models

next page »
Removing and installing the camshaft Hall sensor