REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Nissan Micra (2002 model year)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Nissan
	Micra
		Introduction
		Controls and operation receptions
		Options and car routine maintenance
		Engine
		The engine cooling system, heating, ventilation and air conditioning
		The power supply system and exhaust
		Systems of an electric motor
		Manual box of a gear change and clutch
		Automatic Transmission
		Drive shafts, steering knuckles and Hub assembly
			general information
			Removing and installing the steering knuckle
			Replacing anther drive shafts
			Removing and installing drive shafts
			Disassembly and assembly of the drive shaft
			Removing and installing the hub of the rear wheel assembly
		Brakes
		Suspension and steering
		Body
		Onboard electric
		Diagrams

printable version

Disassembly and assembly of the drive shaft

Assemble the right drive shaft shown in the illustration below. On the left there is no drive shaft vibration damper.

Assemble the right drive shaft

1, 10 - Bellow
2, 11, 13 - Locking ring
3, 12 - Assembling SHRUS
4, 8 - banding
5 - Vibration damper
6 - Clamps
7 - Drive Shaft
9 - Joint Tripodny

Dismantling

PERFORMANCE ORDER

Remove the banding.
Clamp the shaft in a vice with soft metal jaws and remove the retaining ring and the housing inner CV joint.

Apply a paint mark on the shaft and tripodny hinge.

Remove the retaining ring and remove tripodny joint from the drive shaft.
Remove the shaft boot.
Remove banding and slide from the outer CV joint boot.
Remove the constant velocity joints (see para. and clean paper towel holder of the hinge of old greasing. Check the condition of the joint, and replace it if necessary.
Remove the drive shaft boot and lock ring
If necessary, remove the drive shaft from the right vibration damper, having removed his collars.

Assembly

PERFORMANCE ORDER

To build the shaft from the wheel, proceed in accordance with paragraphs 13 to 20.
Wrap the splined portion of the shaft from the transmission belt to prevent damage to the boot during installation. Install a new boot on the shaft and the new banding anther.
Remove the protective tape and replace the drive shaft tripodny side dish, combined the labels put at removal.
Secure tripodny garnish a new lock ring.
Tamp tripodny garnish grease and set him cover.
Tamp in a casing 115 ?� 5g grease.

Securely install boot into grooves (* in the illustration), after removing the grease from the surfaces marked with *.

Make sure that the length of the boot (L) of 96.5 ?� 1 mm. Bend the edge of a screwdriver (from the larger diameter) anther and bleed air to prevent deformation of the boot.

Secure the inner CV joint boot the new banding in accordance with the illustration.

Turning CV joints, make sure that the situation does not change the boot. Otherwise, install a new boot.

If filmed vibration damper, install it according to the figure.

« previos page
Removing and installing drive shafts

next page »
Removing and installing the hub of the rear wheel assembly